1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by BossHoss

  1. BossHoss
    Post

    bed heater upgrade?

    Ok, that's what I think i was looking for. The weak spots vs. dead spots part is what i was missing from the earlier post. I'm more inclined to...
    Post by: BossHoss, May 16, 2016 in forum: General Questions
  2. BossHoss
    Post

    bed heater upgrade?

    Now, I understand that doubling the source voltage is going to double my wattage, but I'm not exactly clear on how upping my wattage service is...
    Post by: BossHoss, May 15, 2016 in forum: General Questions
  3. BossHoss
    Post

    bed heater upgrade?

    I dont need super high temps, but all of my prints whether they're PLA, ABS, or PETG have issues sticking behind the robo "R". i've got my speeds...
    Post by: BossHoss, May 15, 2016 in forum: General Questions
  4. BossHoss
    Post

    bed heater upgrade?

    Thanks for the tip. The wiring is something i can handle, but could you point me in the direction of a higher wattage element? I did a little...
    Post by: BossHoss, May 15, 2016 in forum: General Questions
  5. BossHoss
    Thread

    bed heater upgrade?

    I was wondering if anyone had a source for a better heating element for the bed. I've got seriously varied temperatures, and its playing hell on...
    Thread by: BossHoss, May 15, 2016, 14 replies, in forum: General Questions
  6. BossHoss
    Post

    Unresolved HELP Raft sticks to my prints

    Bump up your air gap setting under GENERAL>Skirt and Raft. The 0.0-0.2mm recommendation never worked for me, so I upped it to 0.3-0.35mm...
    Post by: BossHoss, May 2, 2016 in forum: Troubleshooting