1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Brad Whitmoyer

  1. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Thanks for the suggestion! I have a physical disability that effects my fine muscle control so there's no way I could do that! And the people who...
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  2. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Thanks everyone for all the help! I think I'm down to it being a problem with my board. My LEDs and fan for cooling the layers are now dead too....
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  3. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Could my board in my printer be messed up even though I'm not getting an error?
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  4. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    ->M503 <-echo:Steps per unit: <-echo: M92 X80.00 Y80.00 Z800.00 E723.38 <-echo:Maximum feedrates (mm/s): <-echo: M203 X500.00 Y500.00 Z5.00...
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  5. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Do you mean under Options -> EEProm? Interesting, yesterday was the first time I looked in there and it came up but now when I try to get in there...
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  6. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Okay so when I did the G28, instead of the extruder going to the left all the way, it went to the right all the way. In MatterControls, you have...
    Post by: Brad Whitmoyer, Dec 18, 2018 in forum: Troubleshooting
  7. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Do you mean just turning it off at the switch? I've done that.
    Post by: Brad Whitmoyer, Dec 18, 2018 in forum: Troubleshooting
  8. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Nope
    Post by: Brad Whitmoyer, Dec 18, 2018 in forum: Troubleshooting
  9. Brad Whitmoyer
    Thread

    Partial Answer movements and speed doubled

    Hello all, hoping someone can help. I have a robo 3D R1+ and using MatterControls. All of a sudden all of the movements and speeds of the printer...
    Thread by: Brad Whitmoyer, Dec 18, 2018, 19 replies, in forum: Troubleshooting