Recent Content by ColoradoBob

Post

I'm thinking hardware as well, but needed the second opinions. I'll reach out to Robo support and see where it goes. Thanks a ton for the thoughts!

Post by: ColoradoBob, Nov 9, 2017 in forum: Troubleshooting

Post

I agree that it is very strange. I connected Simplify3D Directly to the Printer and took a screen recording of the behavior that also shows the...

Post by: ColoradoBob, Nov 9, 2017 in forum: Troubleshooting

Thread

Hello Everyone, I have some weird behavior I'm hoping someone has encountered and has a solution for. I recently had to replace the RAMPS board...

Thread by: ColoradoBob, Nov 8, 2017, 10 replies, in forum: Troubleshooting

Post

Thanks, I've been using 210C for extruder and 75C for bed with PLA, been working great. I finally got it sorted out. There was a broken wire at...

Post by: ColoradoBob, Jul 7, 2016 in forum: Troubleshooting

Post

Thanks Mark, I Ohmed out the Thermistor and it seemed okay. I traced the wire back to the RAMPS board and it looked okay, but I unplugged and...

Post by: ColoradoBob, Jul 7, 2016 in forum: Troubleshooting

Thread

O.k., so this has been weird for me so I'm turning to all of you for help. I've had my printer for about 5 months and things have been great. I...

Thread by: ColoradoBob, Jul 6, 2016, 4 replies, in forum: Troubleshooting