1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by EricTXMechEngr2017

  1. EricTXMechEngr2017
    Post

    Partial Answer 3D Printing Newbie with Multiple Printing Issues.

    I'll try this out tonight after work, hopefully that is the case, I was having doubts on the firmware I loaded onto it after replacing the MEGA...
    Post by: EricTXMechEngr2017, Feb 24, 2018 in forum: Troubleshooting
  2. EricTXMechEngr2017
    Post

    Partial Answer 3D Printing Newbie with Multiple Printing Issues.

    I'm no one hundred percent sure if I have the R1 or R1+ but I believe I reloaded a file named Auto_Level_7_17_8mm. Hopefully that's the one you're...
    Post by: EricTXMechEngr2017, Feb 24, 2018 in forum: Troubleshooting
  3. EricTXMechEngr2017
    Post

    Partial Answer 3D Printing Newbie with Multiple Printing Issues.

    [IMG] This is one of the prints after the RAMPS board changes. [IMG] This is one of the prints before the RAMPS change but after the hotend...
    Post by: EricTXMechEngr2017, Feb 24, 2018 in forum: Troubleshooting
  4. EricTXMechEngr2017
    Thread

    Partial Answer 3D Printing Newbie with Multiple Printing Issues.

    Howdy folks, So I have a multitude of problems with my printer, and I want to work hard to diagnose and get my printer up and running again so...
    Thread by: EricTXMechEngr2017, Feb 24, 2018, 6 replies, in forum: Troubleshooting