Recent Content by Harison Kelmer

Post

Hey guys. Heated it up and wiggled the wires as recommended. No change in Temps. That, combined with the fact that I got satisfactory connectivity...

Post by: Harison Kelmer, Jun 23, 2016 in forum: Troubleshooting

Post

The thermistor was replaced today and is seated firmly inside the print head. The set screw is tightened nice and tight. I contacted Robo and...

Post by: Harison Kelmer, Jun 22, 2016 in forum: Troubleshooting

Post

I have been running it with the fan off to make sure it couldn't overrun the heater... So I don't think that could be the problem. Also, I can...

Post by: Harison Kelmer, Jun 22, 2016 in forum: Troubleshooting

Post

Dang it! No luck. Same symptoms! This is with a new thermistor from Robo. I called their tech support and they said it could be an issue with...

Post by: Harison Kelmer, Jun 22, 2016 in forum: Troubleshooting

Post

Now to see if it fixed the problem!

Post by: Harison Kelmer, Jun 22, 2016 in forum: Troubleshooting

Post

figured it out. Thanks!

Post by: Harison Kelmer, Jun 22, 2016 in forum: Troubleshooting

Post

Do I have to remove the print head to install this? I ask because the only set screw I see at all is above the thermistor (as I am looking at the...

Post by: Harison Kelmer, Jun 22, 2016 in forum: Troubleshooting

Post

Thanks. I think the thermistor is bad. I just received the new one today and am getting ready to install it. I had two quick questions though:...

Post by: Harison Kelmer, Jun 22, 2016 in forum: Troubleshooting