Recent Content by JDPhillips

Post

Alrighty, turns out there was a near short in the wire. Ran a new one beginning to end and everything works. Thanks for the help!

Post by: JDPhillips, Jan 24, 2017 in forum: Troubleshooting

Post

Cool, good advice. I'm getting 3.7 Ohms off the unplugged connector at the board. Any idea what it should be? My original thermistor (Which was...

Post by: JDPhillips, Jan 23, 2017 in forum: Troubleshooting

Thread

Greetings all. My Robo 3D is an original Kickstarter unit I've had for awhile. After many, many successful prints using the tedious manual bed...

Thread by: JDPhillips, Jan 22, 2017, 5 replies, in forum: Troubleshooting

Thread

Greetings all. After a few prints i noticed the quality degrading during quick movement printing, such as infill. It was discovered that the...

Thread by: JDPhillips, Jan 3, 2014, 5 replies, in forum: Troubleshooting

Thread

Greetings all. Genuine noob here, just got my Robo3D a few days ago, so i definitely need to lurk more on here, but thought I'd throw up a quick...

Thread by: JDPhillips, Dec 22, 2013, 4 replies, in forum: Troubleshooting