1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by joshua cheers

  1. joshua cheers
    Post

    X & Y axis issues

    I tried to print the off the sd card using the same firmware, same issue no indications to state a fault. the printer was working great until...
    Post by: joshua cheers, Aug 20, 2018 in forum: Mods and Upgrades
  2. joshua cheers
    Post

    X & Y axis issues

    Printing from computer, it doesn’t recover just stays like this and makes a mess of the print that’s already on the bed
    Post by: joshua cheers, Aug 20, 2018 in forum: Mods and Upgrades
  3. joshua cheers
    Thread

    X & Y axis issues

    Hi guys Hoping someone can help me sort out my issues, i am running @Mike Kelly pre modified firmware for his solenoid auto level, with a few...
    Thread by: joshua cheers, Aug 20, 2018, 5 replies, in forum: Mods and Upgrades
  4. joshua cheers
    Thread

    arduino cyclops help

    Hi Guys I am in the process of changing my R1 to run an E3D cyclops hotend. My question is what do i have to change in the firmware to allow both...
    Thread by: joshua cheers, Oct 3, 2017, 2 replies, in forum: Software