1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by LoneStar

  1. LoneStar
    Post

    Partially Solved Auto Leveling Touching 6 of 9 points

    Ok, I have noticed something this time. When the carriage gets to the right side the left side raises up and off of the switch. Odd. I have not...
    Post by: LoneStar, Feb 22, 2016 in forum: Troubleshooting
  2. LoneStar
    Post

    Partially Solved Auto Leveling Touching 6 of 9 points

    I used a set of calipers. The X axis bars are only .0013" out of level. Left side is higher. It's not going to get much closer than that. I have...
    Post by: LoneStar, Feb 20, 2016 in forum: Troubleshooting
  3. LoneStar
    Post

    Partially Solved Auto Leveling Touching 6 of 9 points

    Here is the video I said I would post. This shows the whole g29 auto leveling sequence. I tired to show the switches as well. [MEDIA]
    Post by: LoneStar, Feb 20, 2016 in forum: Troubleshooting
  4. LoneStar
    Post

    Partially Solved Auto Leveling Touching 6 of 9 points

    I do know about the switches. That is what I thought it was as well. Both switches are engaged and seem to be functioning as they should be. I...
    Post by: LoneStar, Feb 20, 2016 in forum: Troubleshooting
  5. LoneStar
    Thread

    Partially Solved Auto Leveling Touching 6 of 9 points

    This is a printer we have in our office at work. It is 3 months old and we have the upgraded version of the R1. It has been working very well. I...
    Thread by: LoneStar, Feb 19, 2016, 12 replies, in forum: Troubleshooting