1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Marco Ramirez

  1. Marco Ramirez
    Thread

    Answered desktop clock robo kit

    Someone could provide me the files to make Desktop Clocks , from the Clock Print Kit Pack, I already bought the filaments of the colors to my...
    Thread by: Marco Ramirez, Mar 17, 2017, 2 replies, in forum: General Questions
  2. Marco Ramirez
    Thread

    Answered 3D printer reprap smart controller Reprap

    hi friends yesterday im install the 3D printer reprap smart controller Reprap , amazing lcd all good BUT............ on the scream said SLEEP not...
    Thread by: Marco Ramirez, Mar 2, 2017, 1 replies, in forum: Troubleshooting
  3. Marco Ramirez
    Post

    Solved Quality or other problem , extruder ? Master Welcome pls.

    In summary it is a normal problem, between the poor quality of the filament and the temperature, The error of extrusion prevent is by low...
    Post by: Marco Ramirez, Mar 1, 2017 in forum: Troubleshooting
  4. Marco Ramirez
    Post

    Solved Quality or other problem , extruder ? Master Welcome pls.

    tks
    Post by: Marco Ramirez, Mar 1, 2017 in forum: Troubleshooting
  5. Marco Ramirez
    Post

    Solved Quality or other problem , extruder ? Master Welcome pls.

    If I think about it, that happened with the last meters of the filament roll, could that be?
    Post by: Marco Ramirez, Mar 1, 2017 in forum: Troubleshooting
  6. Marco Ramirez
    Post

    Partially Solved Stringing or Oozing

    tks very much
    Post by: Marco Ramirez, Mar 1, 2017 in forum: Troubleshooting
  7. Marco Ramirez
    Thread

    Solved Quality or other problem , extruder ? Master Welcome pls.

    In the photo print 3d B (orange)is when my printer was normal, after a jam problems with the extruder already solved, continue printing as the...
    Thread by: Marco Ramirez, Mar 1, 2017, 8 replies, in forum: Troubleshooting
  8. Marco Ramirez
    Post

    Partially Solved Stringing or Oozing

    how can i calibrated the printer , its only with print a cube calibrated or need to make some thing else
    Post by: Marco Ramirez, Feb 28, 2017 in forum: Troubleshooting
  9. Marco Ramirez
    Post

    Partially Solved Stringing or Oozing

    you said the Marlin 1.1.0 firmware. its better ?
    Post by: Marco Ramirez, Feb 28, 2017 in forum: Troubleshooting
  10. Marco Ramirez
    Post

    Partially Solved Stringing or Oozing

    im not up date mine , so its defaut of Factory , im buy mine 6 months ago. im gone check later . tks
    Post by: Marco Ramirez, Feb 28, 2017 in forum: Troubleshooting
  11. Marco Ramirez
    Post

    Partially Solved Stringing or Oozing

    tks ,, i have the R1+ but i dont now the firmware ? im gone see later
    Post by: Marco Ramirez, Feb 28, 2017 in forum: Troubleshooting
  12. Marco Ramirez
    Post

    Partially Solved Stringing or Oozing

    im up of 190c to 195c, I put the temperature up a bit, I'll try later
    Post by: Marco Ramirez, Feb 28, 2017 in forum: Troubleshooting