Marquis Johnson

Hi friend, can you help me with this problem. tanks

http://community.robo3d.com/index.php?threads/bowden-upgrade-for-robo-3d-r1-lead-screws-upgraded.20765/

Thanks for all your videos. I downloaded all of them so I can always use them for reference. I was hopping that you solved your transistor switch problem and create a new video. I would like to upgrade to the dual extruder setup. I have to go slow.
Do you know if using the LCD controller and Octoprint are compatable?

hi marquis
first off i want to say thank you for all your videos they been very useful, keep them coming. i have a very important question, do you have a working firmware for i could use for they arduino board? i got a lcd pretty much like the one you got and i cannot get it to work. also if you have any better suggestion as far a software goes so i can finally dish matter control. please help.


than you ahead.