1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Michele Limon

  1. Michele Limon
    Post

    Cura don´t recognice .. but webpage does ..

    Close to the worflow i reached .. Cura>STL>Save in PC>Octoprint>Upload>Print .. Like the interface in cura, cause it helps me manipulate the Stl...
    Post by: Michele Limon, Mar 24, 2017 in forum: General Questions
  2. Michele Limon
    Post

    Cura don´t recognice .. but webpage does ..

    And when i slice it .. and says "print with OctoPrint" ( image below ) where that file goes ?, i don't see it in the web browser unles i load it...
    Post by: Michele Limon, Mar 24, 2017 in forum: General Questions
  3. Michele Limon
    Post

    Cura don´t recognice .. but webpage does ..

    I'm doing it by ethernet .. Not WiFi allowed .. and i'm connected to Octoprint as well .. I was curious/Trying to undestand cura .. wich as far...
    Post by: Michele Limon, Mar 24, 2017 in forum: General Questions
  4. Michele Limon
    Post

    Cura don´t recognice .. but webpage does ..

    Thanks mark for the rapid response .. Perhaps you can explain to me better, what's the correct workflow to print .. with out the usb drive .. And...
    Post by: Michele Limon, Mar 24, 2017 in forum: General Questions
  5. Michele Limon
    Thread

    Cura don´t recognice .. but webpage does ..

    Hi guys .. Newbie here .. Trying to link my computer to the C2, upgrade firmwares .. lastest things and all .. The cura software goes like this...
    Thread by: Michele Limon, Mar 24, 2017, 12 replies, in forum: General Questions
  6. Michele Limon
    Post

    Solved C2 PLA doesn't stick to plate

    I'm trying 2ble face tape .. first attempt goes well .. let you know if still goes well on later on attempts .. Thanks everyone !! ..
    Post by: Michele Limon, Mar 24, 2017 in forum: Troubleshooting
  7. Michele Limon
    Post

    Solved C2 PLA doesn't stick to plate

    It's not a heated plate .. it's a C2 model .. Aquanet goes right ? thanks for the response ..
    Post by: Michele Limon, Mar 23, 2017 in forum: Troubleshooting
  8. Michele Limon
    Profile Post

    Newbie here .. requiers some pacience.

    Newbie here .. requiers some pacience.
    Status update by Michele Limon, Mar 23, 2017
  9. Michele Limon
    Thread

    Solved C2 PLA doesn't stick to plate

    Hi every one .. Newbie here .. very quick .. print 1 model , it's stick to the plate, next model .. PLA comes normal .. but doesn't stick to plate...
    Thread by: Michele Limon, Mar 23, 2017, 9 replies, in forum: Troubleshooting