1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Mr.JJ

  1. Mr.JJ
    Post

    Solved Z axis drop into print

    Allright, today I was able to print a nice XYZ calibration cube that came out pretty good. So the Z problem really was because of bad stepper...
    Post by: Mr.JJ, Oct 6, 2021 in forum: Troubleshooting
  2. Mr.JJ
    Post

    Solved Z axis drop into print

    Well the misplaced drivers are done for sure. I got the extruder, X and Z axis working again. Now the Y axis is 100% unresponsive. The Y motor is...
    Post by: Mr.JJ, Oct 4, 2021 in forum: Troubleshooting
  3. Mr.JJ
    Post

    Solved Z axis drop into print

    So this morning I went to my local HW store to get some A4988 modules. I've swapped the drivers and tried the printer and nothing works now! The...
    Post by: Mr.JJ, Oct 3, 2021 in forum: Troubleshooting
  4. Mr.JJ
    Post

    Solved Z axis drop into print

    Will keep you up to date when I change them. Do you have a picture of the drivers on the board? Just to be sure I put them at the right place....
    Post by: Mr.JJ, Oct 2, 2021 in forum: Troubleshooting
  5. Mr.JJ
    Post

    Solved Z axis drop into print

    Here you go! To be clear I did have the same problem before "updating" the firmware but hey you never know.
    Post by: Mr.JJ, Oct 2, 2021 in forum: Troubleshooting
  6. Mr.JJ
    Thread

    Solved Z axis drop into print

    Hi everyone. My friend gave me his old R1 printer hoping for me to fix it. It's starting to print well but after about 10 layers the printing head...
    Thread by: Mr.JJ, Oct 2, 2021, 14 replies, in forum: Troubleshooting