1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Nic Phillips

  1. Nic Phillips
    Post

    Unanswered Adjusting Z Endstop for Leveling?

    Correct, there is a spot for custom start-up GCode. I should have been more clear with my question. What I actually meant was, where in the...
    Post by: Nic Phillips, Apr 7, 2016 in forum: Troubleshooting
  2. Nic Phillips
    Post

    Unanswered Adjusting Z Endstop for Leveling?

    Good to know. Thanks for the pointer. So, to take this approach with MC, I would leave the Z offset in the GUI set to 0 and then just add the...
    Post by: Nic Phillips, Apr 7, 2016 in forum: Troubleshooting
  3. Nic Phillips
    Post

    Unanswered Adjusting Z Endstop for Leveling?

    Thanks Mark, MatterControl has a Z-Offset setting built right into the GUI, which I believe eliminates the need for a M565 command, right? (There...
    Post by: Nic Phillips, Apr 6, 2016 in forum: Troubleshooting
  4. Nic Phillips
    Post

    Unanswered Adjusting Z Endstop for Leveling?

    So, I'm too anxious/impatient, and decided to get started on the process of leveling the bed prior to receiving any responses to my initial...
    Post by: Nic Phillips, Apr 6, 2016 in forum: Troubleshooting
  5. Nic Phillips
    Thread

    Unanswered Adjusting Z Endstop for Leveling?

    So, my R1's auto-leveling doesn't seem to be quite hitting the mark. Specifically, the Y gap seems to grow when moving from the front to the back...
    Thread by: Nic Phillips, Apr 6, 2016, 9 replies, in forum: Troubleshooting
  6. Nic Phillips
    Post

    Unanswered Edges lifting/warping

    Oops! I forgot to drop it back down, which I meant to do. At any rate, I also forgot to rotate the print orientation as I mentioned in my last...
    Post by: Nic Phillips, Mar 9, 2016 in forum: Troubleshooting
  7. Nic Phillips
    Post

    Unanswered Edges lifting/warping

    I ran a third print with much better results. For those who want the technical details, I am using MatterControl with MatterSlice as the slice...
    Post by: Nic Phillips, Mar 9, 2016 in forum: Troubleshooting
  8. Nic Phillips
    Post

    Unanswered Edges lifting/warping

    I think it's a cooling issue. I lowered the in-fill a bit so that there will be less hot plastic retracting to pull up on the edges and I'm going...
    Post by: Nic Phillips, Mar 8, 2016 in forum: Troubleshooting
  9. Nic Phillips
    Post

    Unanswered Edges lifting/warping

    I tried both of the above suggestions (used more hairspray and raised the extruder temp a couple degrees), but got the same result. Any other...
    Post by: Nic Phillips, Mar 8, 2016 in forum: Troubleshooting
  10. Nic Phillips
    Thread

    Unanswered Edges lifting/warping

    I apologize if this has been addressed elsewhere. I searched, but couldn't find a thread with an answer. Yesterday, I tried to print out one...
    Thread by: Nic Phillips, Mar 7, 2016, 17 replies, in forum: Troubleshooting