Separate names with a comma.
Is your PC going into sleep mode? Make sure that's turned off. I would get a PI and install OctoPrint.
Attached is the Config file I'm using with Marlin 188.8.131.52. I have installed an E3D V6 hot end and a BLTouch v3.1.
I use Arduino IDE 1.8.16 for...
I think you have to use Servo 0 or you'll need to change the ramps pin file in Marlin.
Can you change to Servo 0?
What does your Gcode look like? Does it have this in the beginning to home the axes and probe the bed?
G28 ; Home all axes
G29 ; Probe the...
I did what this guy did although I had to solder in the missing pins.
Start at 1:30
Attached is the Config file I'm using with Marlin 184.108.40.206. I use Arduino IDE 1.8.16 for compiling and uploading.
I did make 2 changes for the...
Sorry, the Ramps board is referred to as an Arduino Shield.
Ill post my config files up when I get home later. Should work for you.
Do you have the R1+ with the black shield?
Does the BLTouch LED come on?
BLTouch manual has Marlin firmware changes that need to be made.