1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Shaun

  1. Shaun
    Post

    Unresolved Poor Corners

    Thanks @Geof, im just reading through @mark tomlinson 's link. My thoughts where the cornering speed which Mark link seems to cover,, (Jerk...
    Post by: Shaun, Oct 16, 2017 in forum: Troubleshooting
  2. Shaun
    Post

    Unresolved Poor Corners

    yep defiantly ABS, printing temp on label states 210-260c on the label.. I did start at 260 and gradually decreased as i was getting an issue with...
    Post by: Shaun, Oct 16, 2017 in forum: Troubleshooting
  3. Shaun
    Post

    Unresolved Poor Corners

    Hi Geof, Material is ABS Temperature is 195c Bed is 85C on a Kapton Tape/PVA Glue combo (fan disabled for the first layer) Speed Infill 50mm/s...
    Post by: Shaun, Oct 16, 2017 in forum: Troubleshooting
  4. Shaun
    Thread

    Unresolved Poor Corners

    Hi All, since you guys where to helpful previously in my printing Woes im hoping you can help again. My print quality seems to be improving alot...
    Thread by: Shaun, Oct 16, 2017, 9 replies, in forum: Troubleshooting
  5. Shaun
    Post

    Delay In Extrusion (Nylon)

    Hi Mark, Just to update you seem to be having exacatly the same problem, there is a noticable delay between extrusion and filament leaving the...
    Post by: Shaun, May 25, 2017 in forum: Printing Filament
  6. Shaun
    Post

    Delay In Extrusion (Nylon)

    Hi Mark, I will try to go up a few degree's and see if that helps. The filament was straight out of the sealed pack yesterday so i dont think...
    Post by: Shaun, May 23, 2017 in forum: Printing Filament
  7. Shaun
    Post

    Delay In Extrusion (Nylon)

    Thanks again for your reply Mark,, After the mess i made in the trials i dont think im going to try anything on a the bed until i can get...
    Post by: Shaun, May 22, 2017 in forum: Printing Filament
  8. Shaun
    Post

    Delay In Extrusion (Nylon)

    Thanks for the reply Mark. I dont think i have an issue with the temperatures, i can get it to extrude between 250-265 and if its doing a long...
    Post by: Shaun, May 22, 2017 in forum: Printing Filament
  9. Shaun
    Post

    Delay In Extrusion (Nylon)

    Thank you for the response Mark.. The Nylon im trying to use is found on RS Components Part Number 832-0507 I've been experimenting a little,...
    Post by: Shaun, May 22, 2017 in forum: Printing Filament
  10. Shaun
    Thread

    Delay In Extrusion (Nylon)

    Hi All Newbie here., I tried using the search but coming up with blanks, I recently purchased a Robo R1 Plus 3D printer, all was going well...
    Thread by: Shaun, May 22, 2017, 14 replies, in forum: Printing Filament