1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Stargrove1

  1. Stargrove1
    Post

    MicroCube printer

    Without the cable loop, it would have fit completly into the Robo3D :) Heated bed would of course be possible, but my Robo3D has one, my Rostock...
    Post by: Stargrove1, Dec 30, 2016 in forum: Show and Tell
  2. Stargrove1
    Thread

    MicroCube printer

    Hi guys, I'd like to share my latest project built with the Robo3D (and some parts with my delta in parallel). Let me introduce the MicroCube, a...
    Thread by: Stargrove1, Dec 29, 2016, 3 replies, in forum: Show and Tell
  3. Stargrove1
    Post

    3D scanning with kinect 1

    Thank you for sharing your expirience. Ill try to check out Artec Studio.
    Post by: Stargrove1, Dec 29, 2016 in forum: Software
  4. Stargrove1
    Thread

    3D scanning with kinect 1

    Hello, is anybody using a Microsoft kinect of the first generation to perform 3D scanning? I have tried some tools, only working one I found was...
    Thread by: Stargrove1, Nov 13, 2016, 4 replies, in forum: Software
  5. Stargrove1
    Post

    Solved Limit switch spec.

    Thank you Mark, since there are many of these micro switches available, I was in doubt about the position of the holes to be compatible to the...
    Post by: Stargrove1, May 27, 2016 in forum: Troubleshooting
  6. Stargrove1
    Thread

    Solved Limit switch spec.

    Hi guys, by a manual movement of the z axis, the wire of the limit switch got caught and ripped a piece away from the housing of the z axis...
    Thread by: Stargrove1, May 27, 2016, 3 replies, in forum: Troubleshooting