1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by ted le sueur

  1. ted le sueur
    Post

    Solved Endstop Cable

    Hi Mark, Thank you for your help and the link, all i needed was the name of the connector, 'Crimp'. I've ordered some and can soon be back to...
    Post by: ted le sueur, May 16, 2018 in forum: Troubleshooting
  2. ted le sueur
    Thread

    Solved Endstop Cable

    Hi, Does anyone know where I could purchase a replacement for the endstop cable? Unfortunately, the connector that goes into the endstop is...
    Thread by: ted le sueur, May 15, 2018, 4 replies, in forum: Troubleshooting
  3. ted le sueur
    Post

    Answered z axis steppers stop auto moving half way through print- help

    So the fan is working all smoothly on the back, checked the circuit board for loose wires and followed the z axis wires and all seem well. The z...
    Post by: ted le sueur, May 8, 2017 in forum: Troubleshooting
  4. ted le sueur
    Post

    Answered z axis steppers stop auto moving half way through print- help

    unfortunatly all the fans are working nicely and temp seems okay. Yet the z axis still wont engage
    Post by: ted le sueur, May 6, 2017 in forum: Troubleshooting
  5. ted le sueur
    Post

    Answered z axis steppers stop auto moving half way through print- help

    Do you think this is a overheating problem then? thank you, i will try this now
    Post by: ted le sueur, May 6, 2017 in forum: Troubleshooting
  6. ted le sueur
    Thread

    Answered z axis steppers stop auto moving half way through print- help

    Hi, a few times now, half way through my prints the z axis steppers stop auto moving after each layer. It is currently set to self raising itself...
    Thread by: ted le sueur, May 6, 2017, 7 replies, in forum: Troubleshooting