1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Tim Voges

  1. Tim Voges
    Post

    Unanswered Print bed showing incorrect temps.

    The thermistor is integrated into the new print bed. I will check all the wiring. But signs are pointing the RAMPS board. Any advice on where I...
    Post by: Tim Voges, Jan 29, 2024 in forum: Troubleshooting
  2. Tim Voges
    Post

    Unanswered Print bed showing incorrect temps.

    Thanks for the advice. My problem is the bed temp is showing 60+ degrees and when not heating. This is the same with old and new print bed.
    Post by: Tim Voges, Jan 29, 2024 in forum: Troubleshooting
  3. Tim Voges
    Post

    Unanswered Print bed showing incorrect temps.

    So I replaced the print bed and still the issue with the print bed temps reading at 60+ degrees without preheating. Any suggestions on next step...
    Post by: Tim Voges, Jan 27, 2024 in forum: Troubleshooting
  4. Tim Voges
    Post

    Unanswered Print bed showing incorrect temps.

    Thanks for the advice! I ordered the needed parts from them.
    Post by: Tim Voges, Dec 30, 2023 in forum: Troubleshooting
  5. Tim Voges
    Thread

    Unanswered Print bed showing incorrect temps.

    Hello robo community! I have a R1+ with print bed temp issue. Temp is showing 65 degrees when not heated and will not come down below 58. Hot...
    Thread by: Tim Voges, Dec 27, 2023, 9 replies, in forum: Troubleshooting