1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Vacrin

  1. Vacrin
    Post

    Unresolved Z Step not always occurring during prints.

    Well that's good! Ohhh haven't seen a resettable fuse before, interesting to know. Yeah I've got a autolevel R1, with 8mm rods I believe, i have...
    Post by: Vacrin, Oct 30, 2023 in forum: Troubleshooting
  2. Vacrin
    Post

    Unresolved Z Step not always occurring during prints.

    Hmmm am I doing anything wrong with the pictures? Do they have to be linked in any particular way?
    Post by: Vacrin, Oct 30, 2023 in forum: Troubleshooting
  3. Vacrin
    Post

    Unresolved Z Step not always occurring during prints.

    Might have to replace the whole board, more than just the small stepper ones... Noticed this, but thought it might not be that big of an issue...
    Post by: Vacrin, Oct 30, 2023 in forum: Troubleshooting
  4. Vacrin
    Post

    Unresolved Z Step not always occurring during prints.

    Will poke around and see what I find, yeah that could definitely be the issue. Will probably do both, but that's just because I like tinkering...
    Post by: Vacrin, Oct 30, 2023 in forum: Troubleshooting
  5. Vacrin
    Thread

    Unresolved Z Step not always occurring during prints.

    Sooo not sure if people are still active here, plus I have quite an old printer atm. I've got a ROBO3D R1 from 2015, trying to get it back up and...
    Thread by: Vacrin, Oct 29, 2023, 9 replies, in forum: Troubleshooting