1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Vaidher

  1. Vaidher
    Post

    Solved Not even sure...

    Funny you mention that, I went ahead and tightened up a few things and put my printer on a sturdier table and my next print came out flawless!...
    Post by: Vaidher, Jul 16, 2016 in forum: Troubleshooting
  2. Vaidher
    Post

    Solved Not even sure...

    Thanks everyone! I think I have it dialed back in. I believe most of the problem was the z axis nut coming loose on the right side. I wasn't...
    Post by: Vaidher, Jul 16, 2016 in forum: Troubleshooting
  3. Vaidher
    Post

    Solved Not even sure...

    Z axis nut on the right side was a little off due to the bracket being loose. I tightened it up and tried ABL again and it printed exactly the...
    Post by: Vaidher, Jul 15, 2016 in forum: Troubleshooting
  4. Vaidher
    Post

    Solved Not even sure...

    Paper test is showing the right side is a little bit higher. So do I need to turn off ABL and just manual it everytime?
    Post by: Vaidher, Jul 15, 2016 in forum: Troubleshooting
  5. Vaidher
    Thread

    Solved Not even sure...

    my guess is the bed is not leveling correctly... Used glue on this run so I apologize for the dirty bed but if you look at the circle it is...
    Thread by: Vaidher, Jul 14, 2016, 10 replies, in forum: Troubleshooting
  6. Vaidher
    Post

    Unanswered Prints are stopping...Where to start?

    Bummer! On a side note, just another observation; My LED's have always flickered when printing. Is that common? I'm wondering if I have a bad...
    Post by: Vaidher, Jun 13, 2016 in forum: Troubleshooting
  7. Vaidher
    Post

    Unanswered Prints are stopping...Where to start?

    Thanks for the reply Geof, Flicked it and nothing happened lol. The blades do move if touched so its not jammed. It is plugged up correctly and...
    Post by: Vaidher, Jun 13, 2016 in forum: Troubleshooting
  8. Vaidher
    Post

    Unanswered Prints are stopping...Where to start?

    Everything is plugged in; I guess I just got a new dud. Thanks Mark
    Post by: Vaidher, Jun 13, 2016 in forum: Troubleshooting
  9. Vaidher
    Post

    Unanswered Prints are stopping...Where to start?

    Hi Mark, you are correct, the fan is not turning on at all. :(
    Post by: Vaidher, Jun 13, 2016 in forum: Troubleshooting
  10. Vaidher
    Post

    Unanswered Prints are stopping...Where to start?

    Thanks for the quick feedback guys. To be continued....
    Post by: Vaidher, Jun 13, 2016 in forum: Troubleshooting
  11. Vaidher
    Thread

    Unanswered Prints are stopping...Where to start?

    Hello everyone, I have had my Robo R1 Plus for a few weeks and it has begun to stop printing randomly. It has stopped at 95% of a print or it...
    Thread by: Vaidher, Jun 13, 2016, 14 replies, in forum: Troubleshooting