1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Bed temp not working

Discussion in 'Troubleshooting' started by Poplip200, Feb 2, 2017.

Thread Status:
Not open for further replies.
  1. Poplip200

    Poplip200 New Member

    Joined:
    Dec 8, 2016
    Messages:
    11
    Likes Received:
    2
    I had this problem with the hotend and fixed it but now the beds not working and instead of being 60 it drops to like 55 and fails the print
     
    #1 Poplip200, Feb 2, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    What errors are you getting in the console?
    Usually the bed heater has problems due to the RAMPS board output MOSFET having issues.
     
    #2 mark tomlinson, Feb 3, 2017
  3. Poplip200

    Poplip200 New Member

    Joined:
    Dec 8, 2016
    Messages:
    11
    Likes Received:
    2
    Somehow fixed by turning my printer off for a day
     
    #3 Poplip200, Feb 3, 2017
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Could be the mosfet over heating. Make sure the fan on the bottom of the printer is running full-speed all the time.
     
    #4 mark tomlinson, Feb 3, 2017
  5. Poplip200

    Poplip200 New Member

    Joined:
    Dec 8, 2016
    Messages:
    11
    Likes Received:
    2
    It is it fine now
     
    #5 Poplip200, Feb 3, 2017
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page