1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Still - Y axis only moving in one direction

Discussion in 'Troubleshooting' started by Tom Finzel, Feb 6, 2017.

Thread Status:
Not open for further replies.
  1. Tom Finzel

    Tom Finzel Member

    Joined:
    Jan 10, 2016
    Messages:
    35
    Likes Received:
    8
    Ok, I don't know how to ref my other thread since I marked it solved but it was titled

    Y axis only moving in one direction.

    I swapped the Robo RAMPS board with a generic one and all 5 stepper drivers and I still have the same symptoms as before.

    I'm guessing the only thing left is to swap the Arduino board. I picked up a couple at Microcenter and loaded RC8 Mesh Plus from the forum on to it.

    I also put RC8 on my suspicious board and no change.

    After this I'm out of things to check or swap.
     
    #1 Tom Finzel, Feb 6, 2017
    Last edited by a moderator: Feb 6, 2017
  2. Tom Finzel

    Tom Finzel Member

    Joined:
    Jan 10, 2016
    Messages:
    35
    Likes Received:
    8

    Turns out it was my Ardruino board. Flashed the firmware onto a Microcenter Arduino board and mounted my original Robo R1+ RAMPS board and I'm back to printing. Finally!!!
     
    #2 Tom Finzel, Feb 7, 2017
    Rigmarol and mark tomlinson like this.
Thread Status:
Not open for further replies.

Share This Page