1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer X and Y axis homing issue

Discussion in 'Troubleshooting' started by Lance Jimenez, Jun 16, 2017.

  1. Lance Jimenez

    Lance Jimenez New Member

    Joined:
    Aug 21, 2016
    Messages:
    7
    Likes Received:
    0
    Morning everyone this morning when I went to home all of the axis on robo 3d plus printer my x and y axis sensors do not seem to be working as the printer tries to go beyond the limit of both axis I will note two things one I was doing some cleaning of the fans and extruder involving completely removing them beforehand and two I am fairly new at this so you may have to walk me through how to fix this if you can I would really appreciate the help thanks guys.
     
    #1 Lance Jimenez, Jun 16, 2017
  2. Ryan TeGantvoort

    Ryan TeGantvoort Active Member

    Joined:
    Mar 11, 2016
    Messages:
    343
    Likes Received:
    172
    You can use M119 in your communication terminal to test end stops status.
     
    #2 Ryan TeGantvoort, Jun 19, 2017
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    first I'd look at see if both the x and y endstops are still attached and wires fell off. Next I'd suggest (if plugged in via USB) unplugging the USB and turn the printer off for a bit then back on (reset). The machine will NOT reset if the USB is plugged in. (please provide a little more information on what you did when you talk about removing fan and extruder)
     
    #3 Geof, Jun 19, 2017

Share This Page