1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

A Couple of projects

Discussion in 'Show and Tell' started by tkoco, Apr 19, 2020.

  1. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    The bins were printed on my C2 printer. The bracket was printed on my R2 printer.

    The two bins are the same "vase" file but scaled differently. ( File is from Thingiverse.com )

    The bracket was modeled on the FreeCAD software since it was a "one of a kind" project.

    And they were both printed in PLA.

    project.jpg
     
    #1 tkoco, Apr 19, 2020
    mark tomlinson likes this.

Share This Page