Solved Only one header on RAMPS 1.4?

I had issues with the original RAMPS sheild burning the connectors for the hbp and put in a replacement request after that cascaded into an ultimately broken sheild. The original has two headers for the Z axis motors, while the replacement only has one, from what I can tell.

What do I do? It'd be a simple task to wire the motors together. Is this viable, or is there anything I'm missing?

EDIT: Disregard -- I found what I was looking for. Just not where I expected it to be.

 

To answer his question for anyone else. Robo transitioned to a new RAMPS that uses 2 stepper drivers for Z, now there's a Z0 at the old position and a Z1 at the old E1 position. They share the same pins