R1+ Owner in California

Hello!

I have previously owned a i3 Prusa, Rostock Max, Da Vinci 1.0, and now a R1+. I've had my R1+ for two weeks, put on 56hrs and have had better prints on this one than any others I've had. I've only ran the pearl PLA's through it but have only had 1 fail (lift off the bed) in about 18 different print times and about 4 of them had 3 to 6 pieces on one print.

I'm using Simplify3d because the first 2 prints off Matter Control had REALLY bad prints where the supports were on a curve. I just bought the Carbon Fiber PLA and will drop off the deep end soon with some Nylon and T-Glase. Hope to have a lot of fun I couldn't have on my previous printers!

 

what part of cali?

 

Sacramento

 

All right!!! I'm in Elk Grove.

 

Vallejo...


Sent from my iPhone using Tapatalk

 

I think you make the best/a good choice! Welcome!