1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Flexible Filament

Discussion in 'General Questions' started by Cbrown, Jul 9, 2016.

  1. Cbrown

    Cbrown Member

    Joined:
    Mar 19, 2016
    Messages:
    94
    Likes Received:
    4
    This any any mobs you can make to the standard assembly to print flexible filament easier without buying a e3d or etc.
     
    #1 Cbrown, Jul 9, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    #2 mark tomlinson, Jul 9, 2016
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    #3 mark tomlinson, Jul 9, 2016
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    General settings are going to be hot and slow.
    Print on the hotter side of the band and really (really!) slow ...
    Experiment and you get get it working.
     
    #4 mark tomlinson, Jul 9, 2016
  5. JoshYourITGuy

    JoshYourITGuy Active Member

    Joined:
    May 27, 2015
    Messages:
    131
    Likes Received:
    33
    This Thing along with the E3D V6 really helped me out. I also have a Volcano at work and can print faster than the stock E3D at home.
    http://www.thingiverse.com/thing:1126255
    You can also print with the stock Hexagon with this Thing as well, albeit a bit slower.
     
    #5 JoshYourITGuy, Jul 12, 2016
    Last edited: Jul 12, 2016

Share This Page