Solved Part fell off printer

Hi,
I realized this part detached itself from the printer (see picture). Do you guys know what it is, where it should be and how to reinstall it?
Thanks.

 

That is the clip for the Ribbon Cable that attaches to the Heater. I removed mine a long time ago as it was causing problems with my bed getting hung up. Just make sure your Ribbon Cable is between the Bed and the End Rail Supports and you will be fine. No need to reinstall.

 

Alright, thanks! I'd appreciate is someone was kind enough to post a picture of it's original position. Thanks!

 

http://community.robo3d.com/index.php?threads/y-axis-crash.8093/#post-70891

I am currently printing something otherwise I would throw it back in and snap a picture. But I found these pictures that show where it is located. On the back side of the bed there are two holes/screws, one is to tension the Y-axis belt and the other (right side when looking at the front of the printer) is where that clip goes.

 

Awesome, thanks!