Unanswered May have shorted pc fan and x endstop

Only for a few seconds as I was trying to resolder and test the OC fan and I saw smoke pouring out of the robo3d r1 and cut power and started by pulling the now screws fan out and because I didn't see where the smoke came from started looking at the ramp aboard and it all looks fine so after disconnecting the fan power it back and and auto home it to see what it does and it takes a few seconds due to z stops not being in the right position but get that fixed and it auto homes like a champ haven't yet tested the heater might wait a bit for that no flames just smoke


Sent from my iPhone using Tapatalk

 

Yup everything is working. Heater might take a couple tries but it works bed works too. Haven't tested the extruder but will soon

I even ran the Mario music code and that worked
Sent from my iPhone using Tapatalk

 

I sent in a parts request waiting to hear back from that. Did you get the photo of the damage it did? I also put some heat shrink tube on it to further protect it


Sent from my iPhone using Tapatalk

 

Well it's all working just haven't tested extrusion


Sent from my iPhone using Tapatalk

 

Don't know if it actually shorted but I think it was damn close


Sent from my iPhone using Tapatalk

 

Running a test cube now and so far looking good. No smoke or fire


Sent from my iPhone using Tapatalk

 

so damage isn't bad enough to disable it



Sent from my iPhone using Tapatalk