1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. 0ryanx
    Post

    Solved Extruder Bolt Chews Filament

    Skype with Tech Support figured it out; the stepper configuration in the EPROMM was set to 10 times the normal value, causing the filament to...
    Post by: 0ryanx, Sep 2, 2016 in forum: Troubleshooting
  2. 0ryanx
    Post

    Solved Extruder Bolt Chews Filament

    Well, the motor didn't fix the issue; the printer still chews up the filament. Could it be the hot end? I can see the extruder motor moving...
    Post by: 0ryanx, Aug 29, 2016 in forum: Troubleshooting
  3. 0ryanx
    Post

    Solved Extruder Bolt Chews Filament

    Thanks for that, but I'm still a bit confused. The video goes into the what to do and why to do it, but doesn't go into the how. I THINK I've...
    Post by: 0ryanx, Aug 20, 2016 in forum: Troubleshooting
  4. 0ryanx
    Post

    Solved Extruder Bolt Chews Filament

    Well, I submitted a warranty replacement for the stepper motor. I'll update the thread when I get it in and replaced. Thanks for the help, folks!
    Post by: 0ryanx, Aug 20, 2016 in forum: Troubleshooting
  5. 0ryanx
    Post

    Solved Extruder Bolt Chews Filament

    Please forgive how new I am at this, but how do I check the "stepper motor driver for E on the Ramps board itself," and does this happen often?...
    Post by: 0ryanx, Aug 20, 2016 in forum: Troubleshooting
  6. 0ryanx
    Post

    Solved Extruder Bolt Chews Filament

    I'm not using an oiler, and I've ruled clogs out, so far. I followed suggestion and tried extruding filament with the hot end removed; it feeds...
    Post by: 0ryanx, Aug 20, 2016 in forum: Troubleshooting
  7. 0ryanx
    Post

    Solved Extruder Bolt Chews Filament

    I'm using a top-mounted holder I printed from Thingiverse, but I ruled that out by cutting a 12 inch piece of filament and trying to get that to...
    Post by: 0ryanx, Aug 20, 2016 in forum: Troubleshooting
  8. 0ryanx
    Thread

    Solved Extruder Bolt Chews Filament

    I've had my Robo3D R1+ Plus for 2 months, and have printed more than a dozen times with it, with no issue. A few days ago, though, I moved it to...
    Thread by: 0ryanx, Aug 19, 2016, 25 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 28 of 28
Search Again
Page 2 of 2