1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. KellywithaY
    Post

    Solved PLA Filament stuck, not extruding

    Good to know! I have been eyeing the flexible filament so I'll keep that in mind. After I posted that follow-up, I took one of the screws I had...
    Post by: KellywithaY, May 4, 2017 in forum: Troubleshooting
  2. KellywithaY
    Post

    Solved PLA Filament stuck, not extruding

    That tip (removing the springs) is ingenious. When I made this post this morning, I was afraid I may have gone a little too far taking the cover...
    Post by: KellywithaY, May 4, 2017 in forum: Troubleshooting
  3. KellywithaY
    Thread

    Solved PLA Filament stuck, not extruding

    All I wanted to do was print a Yoda head using translucent green PLA. I mean, May the Fourth, ya'll. Filament: MakerGeek Crystal Series PLA 1.75...
    Thread by: KellywithaY, May 4, 2017, 13 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 23 of 23
Search Again
Page 2 of 2