Separate names with a comma.
I just had to unclog hotend because I had a knot in my spool. My LCD controller know comes up and says MINTEMP. How do I fix this?
I believe when I asked Fleks3d before they recommended you can use a bandsaw. But I have not had to cut mine.
You most likely could laser cut it...
Whoops I responded to the wrong post, I don't know when they held the one in Orlando.
I think they held one in Orlando about a month ago
I went last year to the Maker fairer it was good, theyou had fpv drone racing. Nothing like the other Faires they hold. I will go again this year.
Just curious, is there any fairs or 3d print shows/ conventions coming up in Atlanta?
Also, I am a 3D Hubs Ambassador and was wondering if we...
I read awhile back that with the release of the new Robo some time this summer that there was also going to be a release for a Dual Extruder...
I designed something similar to the Thingiverse link but mine is just a small frame that sits in the corners so you can mount on the front and...
Hmm I have to look a little further into it.
They only showed it close up. No real advertising. You wouldn't know it was a Robo unless you own one.
Mine will not connect to the computer when the lcd is plugged in.
I use Simplify3d and a Reprap LCD Controller
hmm the first time I ran the code it stopped on the first point until the percent finished hit 100% and the second time ( I didn't change anything...
For some reason the head crashed when I ran your code.
Thank you both, I didn't see it as a problem I was just wondering since most of the pictures I see here have the aluminum.
You have a R1+ with an aluminum plate to quick release the hotend? I received mine about 3 weeks ago and it came with a plastic plate.
Yes I saw the pistol lol
Yeah, I know your pain when the print fails on the first few layers. What I do is take a 150 grit sandpaper and sand it off. That's really my only...
I made corner pieces so I could use the binder clips on the front and back.
They are usually quick to reply. Sucks that you have this problem...
The System comes with 2 plates.