1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 3 of 3
  1. Talanvor
    Post

    Issues with my R2 that I have observed

    weird, on the bed location it sounds likefrom the 0,0 mark the file you were printing was set to a bed that was smaller if you set the calibration...
    Post by: Talanvor, Jun 1, 2017 in forum: Troubleshooting
  2. Talanvor
    Post

    Issues with my R2 that I have observed

    what are your Z values from the fine tune? On the bed size is it set correctly in your cura or did you by chance set your printer to a C2?
    Post by: Talanvor, Jun 1, 2017 in forum: Troubleshooting
  3. Talanvor
    Post

    Issues with my R2 that I have observed

    update the firmware to the latest version, and under utilities, wizards, fine tune offsets
    Post by: Talanvor, Jun 1, 2017 in forum: Troubleshooting
  4. Talanvor
    Post

    Issues with my R2 that I have observed

    Yup that completely fixed it - here are a couple photos [ATTACH] Before [ATTACH] After
    Post by: Talanvor, Jun 1, 2017 in forum: Troubleshooting
  5. Talanvor
    Post

    Issues with my R2 that I have observed

    yeah, the supports and rafts in simplify are just too good to let go - waiting for an updated factory file. =/
    Post by: Talanvor, Jun 1, 2017 in forum: Troubleshooting
  6. Talanvor
    Post

    Issues with my R2 that I have observed

    so i just did the fine tune Z and that gave me a much better number and output - seems with the z-home wizard its off by a full millimeter about....
    Post by: Talanvor, Jun 1, 2017 in forum: Troubleshooting
  7. Talanvor
    Post

    Issues with my R2 that I have observed

    I wonder if they all say package number 1 (mine did as well - just unpacked it this evening.) having some z problems on the first through 4th...
    Post by: Talanvor, Jun 1, 2017 in forum: Troubleshooting
Find older messages
Showing results 41 to 47 of 47
Search Again
Page 3 of 3