1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Henradrie
    Thread

    Small gaps while printing petg

    Whenever I print with petg I always get small gaps in the print like the ones shown in the picture. I can't figure out how to get rid of them....
    Thread by: Henradrie, Mar 7, 2020, 2 replies, in forum: Printing Filament
  2. Henradrie
    Post

    Solved Temperature error, base not heating up

    I had some bad experiences with Amazon and online ordering. Spent a lot of time fixing cheap components that barely worked. I've got a shop 2...
    Post by: Henradrie, Feb 18, 2020 in forum: Troubleshooting
  3. Henradrie
    Post

    Solved Bed Adhesion Issues

    Probably the cold front then. Do you notice changes in humidity from day to day? Sent from my SM-G960W using Tapatalk
    Post by: Henradrie, Feb 18, 2020 in forum: Troubleshooting
  4. Henradrie
    Post

    Solved Temperature error, base not heating up

    Skr 1.3 board was actually cheaper. $40 for a control board vs $53 for another mega, not including ramps. Sent from my SM-G960W using Tapatalk
    Post by: Henradrie, Feb 7, 2020 in forum: Troubleshooting
  5. Henradrie
    Post

    Solved Temperature error, base not heating up

    The problem was a bad Arduino. A friend gave me an SKR 1.3 board and it works perfectly, a bit of work to get it going though. Now I know that...
    Post by: Henradrie, Feb 6, 2020 in forum: Troubleshooting
  6. Henradrie
    Post

    Solved Temperature error, base not heating up

    I swapped out the original RAMPS board with a brand new one. Bought from a supplier in town, and the quality was pretty high. I followed the...
    Post by: Henradrie, Jan 29, 2020 in forum: Troubleshooting
  7. Henradrie
    Thread

    Solved Temperature error, base not heating up

    My printer stopped working while heating up. I set the bed and extruder to heat up to the target temperature in MatterControl and when they...
    Thread by: Henradrie, Jan 28, 2020, 8 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 27 of 27
Search Again
Page 2 of 2