1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Tehbatman
    Post

    Solved Auto Leveling & Printing at Very High Z Axis?

    It hits the first point, then continues to rise 2 mm incrementally per point.
    Post by: Tehbatman, Aug 9, 2016 in forum: Troubleshooting
  2. Tehbatman
    Thread

    Solved Auto Leveling & Printing at Very High Z Axis?

    It seems there's a problem with my auto leveling. When I try to run a print, the hot end touches on each of the 9 points. But, instead of...
    Thread by: Tehbatman, Aug 9, 2016, 9 replies, in forum: Troubleshooting
  3. Tehbatman
    Post

    Solved Odd Striation Problem

    It did seem that the set screws were the problem, however, the only test I was able to perform was a small cube. I'll run a larger print overnight...
    Post by: Tehbatman, Aug 8, 2016 in forum: Troubleshooting
  4. Tehbatman
    Thread

    Solved Odd Striation Problem

    Picture for reference. - imgur.com/DTyr3jF- http://imgur.com/3gTb2P7 This problem started, basically, out of the blue a few days ago. I've done...
    Thread by: Tehbatman, Aug 8, 2016, 2 replies, in forum: Troubleshooting
  5. Tehbatman
    Thread

    R3D R1+ Galaxy S7 Bed Mount?

    So I've been looking for a way to mount a camera to my print bed so 1) I can record time lapses, and 2) So the camera would be stationary relative...
    Thread by: Tehbatman, Jun 9, 2016, 4 replies, in forum: General Questions
  6. Tehbatman
    Post

    Unanswered How to remove hotend?

    Yeah, just found this out. Thanks!
    Post by: Tehbatman, May 30, 2016 in forum: General Questions
  7. Tehbatman
    Thread

    Unanswered How to remove hotend?

    I'm looking to replace the hexagon that comes with the R1+, however when I took it out of the extruder it appears there's two locking connectors....
    Thread by: Tehbatman, May 30, 2016, 4 replies, in forum: General Questions
Find older messages
Showing results 21 to 27 of 27
Search Again
Page 2 of 2