1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Deviant Spark
    Thread

    Solved Gluing Parts Together

    Does anyone have recommendations on an adhesive to glue parts together? I tried a Loctite liquid super glue but it didn't do well at all.
    Thread by: Deviant Spark, May 13, 2016, 2 replies, in forum: General Questions
  2. Deviant Spark
    Post

    Solved Sanding Carbon Fiber PLA Prints

    Thanks guys, so XTC-3D prepares the part for painting? I haven't "finished" a print before so is it common to use a prep compound like this first...
    Post by: Deviant Spark, May 2, 2016 in forum: Troubleshooting
  3. Deviant Spark
    Post

    Solved Sanding Carbon Fiber PLA Prints

    I am using the CuraEngine slicer inside MatterControl.
    Post by: Deviant Spark, May 1, 2016 in forum: Troubleshooting
  4. Deviant Spark
    Post

    Solved Sanding Carbon Fiber PLA Prints

    I occasionally get strands or ridges on the outside chassis of the robot I'm making. Typically its in small areas or on arched surfaces. Perhaps I...
    Post by: Deviant Spark, May 1, 2016 in forum: Troubleshooting
  5. Deviant Spark
    Thread

    Solved Sanding Carbon Fiber PLA Prints

    I have been using the carbon fiber filament from Robo 3D and notice that it turns white when I do any sanding on the parts. Does anyone know a...
    Thread by: Deviant Spark, May 1, 2016, 11 replies, in forum: Troubleshooting
  6. Deviant Spark
    Post

    Solved Humming Noise When Powering On

    Upon further review the noise actually seems to be coming from the small fan on the left side of the print head. I had previously rolled this out,...
    Post by: Deviant Spark, Mar 10, 2016 in forum: Troubleshooting
  7. Deviant Spark
    Post

    Solved Humming Noise When Powering On

    Thanks for the information and help. I removed the bottom cover and found there was a piece of packaging foam stuck in the fan you mentioned....
    Post by: Deviant Spark, Mar 10, 2016 in forum: Troubleshooting
  8. Deviant Spark
    Post

    Solved Humming Noise When Powering On

    Interesting, it's currently in a 14hr print so I can't check at the moment but I bet that is the problem. Where do you buy the fan from? I don't...
    Post by: Deviant Spark, Mar 9, 2016 in forum: Troubleshooting
  9. Deviant Spark
    Thread

    Solved Humming Noise When Powering On

    When I first turn on my Robo 3D R1 I get an occasional humming noise for a period of time. It goes away if I power off/on a few times but its...
    Thread by: Deviant Spark, Mar 9, 2016, 16 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again