1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. phreakinuts
    Post

    Answered Axis Shifting

    Although I do seem to get one layer on every print that shifts slightly. Sent from my iPhone using Tapatalk
    Post by: phreakinuts, Jul 23, 2017 in forum: Troubleshooting
  2. phreakinuts
    Post

    Answered Axis Shifting

    So I think I mainly nailed down the printing issues. I had to do a couple of things. The first thing I did was reduced acceleration on the...
    Post by: phreakinuts, Jul 22, 2017 in forum: Troubleshooting
  3. phreakinuts
    Post

    Answered Axis Shifting

    So the biggest question for me are how do I correct these issues? Sorry, I don't know all the components very well and there are very few good...
    Post by: phreakinuts, Jun 17, 2017 in forum: Troubleshooting
  4. phreakinuts
    Thread

    Answered Axis Shifting

    I can't seem to print anything of height. There's always some level shifts. It's getting extremely frustrating. Any ideas? [IMG] Sent from...
    Thread by: phreakinuts, Jun 17, 2017, 7 replies, in forum: Troubleshooting
  5. phreakinuts
    Post

    Unanswered Ninjaflex

    Pics please! Thanks! Sent from my iPhone using Tapatalk
    Post by: phreakinuts, Feb 26, 2016 in forum: General Questions
  6. phreakinuts
    Post

    Unanswered Ninjaflex

    Not printing at all actually, can't seem to get the filament fed into the printer. Sent from my iPhone using Tapatalk
    Post by: phreakinuts, Feb 24, 2016 in forum: General Questions
  7. phreakinuts
    Post

    Unanswered Ninjaflex

    So I tried the tube. In multiple ways. First by cutting about 3 inches off the length and trying to cut an angled opening where the hobbed gear...
    Post by: phreakinuts, Feb 20, 2016 in forum: General Questions
  8. phreakinuts
    Thread

    Unanswered Ninjaflex

    So I've been trolling through quite a few articles and earlier posts. I'm not sure if anyone has posted a definitive answer on this. I recently...
    Thread by: phreakinuts, Feb 16, 2016, 25 replies, in forum: General Questions
Showing results 1 to 8 of 8
Search Again