1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Cather
    Post

    Solved No Z-clearance on first layer

    banolka-- Make the setting in your slicer program, if possible. In my case I used slic3r, and there is neither an M565 or M851 in the code. I...
    Post by: Cather, May 29, 2017 in forum: Troubleshooting
  2. Cather
    Post

    Solved No Z-clearance on first layer

    Back home and fiddling with it. Going to start with .5 and move up/down as needed. Oddly, this printer-- using OctoPrint, Slic3r, and a slic3r...
    Post by: Cather, May 29, 2017 in forum: Troubleshooting
  3. Cather
    Post

    Solved No Z-clearance on first layer

    That's just it. I changed nothing; I cancelled a print, did a new slice, it wasn't working. Used a previously sliced gcode, same problem. I...
    Post by: Cather, May 29, 2017 in forum: Troubleshooting
  4. Cather
    Post

    Solved No Z-clearance on first layer

    Okay, the good news is that it is now extruding properly. Now it's too high, and printing sloppy. Obviously I'm gonna need to fiddle with the...
    Post by: Cather, May 29, 2017 in forum: Troubleshooting
  5. Cather
    Post

    Solved No Z-clearance on first layer

    Oh, and I've verified that filament extrudes normally prior to the print.
    Post by: Cather, May 28, 2017 in forum: Troubleshooting
  6. Cather
    Thread

    Solved No Z-clearance on first layer

    Robo 3D R1 Plus <- Octoprint <- Slic3r From a distance, it looks like it's printing normally-- it does the autolevel test, and everything looks...
    Thread by: Cather, May 28, 2017, 12 replies, in forum: Troubleshooting
  7. Cather
    Post

    Unresolved Firmware update for R1 to support 12864 LCD - Please help

    Well, I've tried switching the cables, and the little knob accomplished nothing. The seller had me recompile with an ancient version of...
    Post by: Cather, Nov 8, 2016 in forum: Troubleshooting
  8. Cather
    Thread

    Unresolved Firmware update for R1 to support 12864 LCD - Please help

    I am not having any success getting my 12864 LCD to work on my R1. I plug in the LCD and power up the printer, and it either lights up and does...
    Thread by: Cather, Nov 7, 2016, 3 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again