1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Mindstar
    Post

    Unresolved Printer Stops after auto leveling

    I'll have to wait for the error to occur again to get the complete error code. I think its not a drop in the temperature.
    Post by: Mindstar, May 25, 2016 in forum: Troubleshooting
  2. Mindstar
    Thread

    Unresolved Printer Stops after auto leveling

    Robo 3D Plus using Simplyfy I get the following error code after the machine completes the auto leveling process: RECEIVED: Bed x: 15.00 y: 20.00...
    Thread by: Mindstar, May 22, 2016, 5 replies, in forum: Troubleshooting
  3. Mindstar
    Post

    Unresolved Getting really frustrated

    Still new at this. Not sure how to tell the temperature differences for each end. I have a lot of reading on the forum to learn from. I didn't...
    Post by: Mindstar, Apr 7, 2016 in forum: Troubleshooting
  4. Mindstar
    Post

    Unresolved Getting really frustrated

    Thanks guys, I got it working again last night. My first test run was a simple little model that had a little problem in the beginning but the...
    Post by: Mindstar, Apr 7, 2016 in forum: Troubleshooting
  5. Mindstar
    Post

    Unresolved Getting really frustrated

    I made the switch to ABS to test it out and to hold off on using an oiler until I can make one using the printer. Still a newbie and wanting to...
    Post by: Mindstar, Apr 6, 2016 in forum: Troubleshooting
  6. Mindstar
    Post

    Unresolved Getting really frustrated

    Thanks for the quick responses. I think I was running the temp between 190-210. The first batches were great. Then it clogged. Tried everything to...
    Post by: Mindstar, Apr 6, 2016 in forum: Troubleshooting
  7. Mindstar
    Thread

    Unresolved Getting really frustrated

    I've had the printer for about three weeks now and got one good week out of it. The first print jobs were amazing then all of a sudden the quality...
    Thread by: Mindstar, Apr 6, 2016, 19 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again