1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Tim Pilcher
    Post

    Solved Matter Control Support

    Thanks for the reply. I have Matter Control, Cura and Simplify3D. I have spent countless hours using other people settings/ideas on how to...
    Post by: Tim Pilcher, Sep 13, 2016 in forum: Troubleshooting
  2. Tim Pilcher
    Post

    Solved Shrinkage

    Hi, For what its worth I use 'Pritt Xtra Strong Green Glue' and nothing lifts of the bed now. Thanks
    Post by: Tim Pilcher, Sep 13, 2016 in forum: Troubleshooting
  3. Tim Pilcher
    Thread

    Solved Matter Control Support

    Hi Guys, I have managed to get Matter Control working perfectly with my ROBO3DR1+ but I'm still having an issue with the support structure not...
    Thread by: Tim Pilcher, Sep 13, 2016, 4 replies, in forum: Troubleshooting
  4. Tim Pilcher
    Post

    Simplify 3D Manual Configuration Settings

    Hi, I have just bought S3D and this will help a lot but can I use this for the +plus version as well?. Many thanks TIM
    Post by: Tim Pilcher, Jun 21, 2016 in forum: Software
  5. Tim Pilcher
    Thread

    Unanswered Weird overhangs and indentations

    Hi Guys, I'm getting these strange overhangs and indentations on the items i'm printing. You can see from the pictures i've included that its like...
    Thread by: Tim Pilcher, Jun 21, 2016, 6 replies, in forum: Troubleshooting
  6. Tim Pilcher
    Thread

    Unanswered Filament clip

    HI Guys, You know the filament clip (the bit that has the 2 silver screws at the back of the extruder) used to pull backwards so that I could...
    Thread by: Tim Pilcher, May 5, 2016, 1 replies, in forum: Troubleshooting
  7. Tim Pilcher
    Post

    Solved PLA Corner Lift

    Hi Mark, Thanks for the reply. I tried a few things I spotted on Cura's website regarding the lift. Turned off extruder fan completely until...
    Post by: Tim Pilcher, May 5, 2016 in forum: General Questions
  8. Tim Pilcher
    Thread

    Solved PLA Corner Lift

    Hi Guys, I'm new to the Robo 3D experience so please go gentle. I am having problems with corner lift on the bed but only in the top left hand...
    Thread by: Tim Pilcher, May 4, 2016, 5 replies, in forum: General Questions
  9. Tim Pilcher
    Post

    Solved Extruder not heating up

    HI, Thanks for the answers. It seems that the connector underneath the machine had fallen out as you mentioned. Once I reseated the connector all...
    Post by: Tim Pilcher, Apr 29, 2016 in forum: Troubleshooting
  10. Tim Pilcher
    Post

    Solved Extruder not heating up

    Thanks for the replies. I'll give it a good look over tonight. Regards TIM
    Post by: Tim Pilcher, Apr 28, 2016 in forum: Troubleshooting
  11. Tim Pilcher
    Thread

    Solved Extruder not heating up

    Hi Guys, Just took in my new Robo R1+ from amazon today, unpacked it and setup according to the instructions. Problem is the Extruder is not...
    Thread by: Tim Pilcher, Apr 27, 2016, 7 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again