1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Gimpel
    Post

    Unanswered Matter Control Vs. Repetier Support Material

    Well I decided to trial S3d for 2 weeks. And I learned a LOT in the process. I will try Cura. However, I don't think I'll ever go back to...
    Post by: Gimpel, Dec 7, 2016 in forum: Troubleshooting
  2. Gimpel
    Post

    Unanswered Matter Control Vs. Repetier Support Material

    That's the thing, the config files are identical. You have to tweak a few things to import the Rep. settings from a pc to a mac, but side by side,...
    Post by: Gimpel, Dec 4, 2016 in forum: Troubleshooting
  3. Gimpel
    Thread

    Unanswered Matter Control Vs. Repetier Support Material

    I use a Mac. Before my Robo3d I used Repetiere, and was pleased with it on my first 'kit' printer. Then I got a robo3d. My friend preferred...
    Thread by: Gimpel, Dec 3, 2016, 7 replies, in forum: Troubleshooting
  4. Gimpel
    Post

    Unanswered Bumpy Final layer

    Matter Control consistently prints out better prints and I can't seem to be able to hone repetier any better. Which is odd because I've heard the...
    Post by: Gimpel, Jun 15, 2016 in forum: Troubleshooting
  5. Gimpel
    Post

    Unanswered Bumpy Final layer

    Thanks I'm trying these settings. I find Matter Control is very slow, and yet gives me better prints... unless I need support material, and then,...
    Post by: Gimpel, Jun 12, 2016 in forum: Troubleshooting
  6. Gimpel
    Post

    Unanswered Bumpy Final layer

    I installed and ran Matter Control and it has the 9point calibration and my prints look beautiful. But I prefer repetier. So I'll try that I...
    Post by: Gimpel, Jun 12, 2016 in forum: Troubleshooting
  7. Gimpel
    Thread

    Unanswered Bumpy Final layer

    a friend of mine gifted me his Robo3d R1 plus. I used to use a two-up and a printrbot. I use repetier. This weekend was my first prints with...
    Thread by: Gimpel, Jun 12, 2016, 7 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again