1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Ibc36070
    Post

    Unanswered Z-stop not working

    Ok, I just used arduino to get the latest firmware uploaded and I get this on connection in matter control " <-start ->Communication State:...
    Post by: Ibc36070, Oct 9, 2016 in forum: Troubleshooting
  2. Ibc36070
    Post

    Unanswered Z-stop not working

    Firmware is the same. Marlin V1?
    Post by: Ibc36070, Oct 9, 2016 in forum: Troubleshooting
  3. Ibc36070
    Post

    Unanswered Z-stop not working

    I did get this from Robo. I have the r1 +plus. pictures of the stops are attached.
    Post by: Ibc36070, Oct 9, 2016 in forum: Troubleshooting
  4. Ibc36070
    Thread

    Unanswered Z-stop not working

    Just got a new (replacement) RAMPS board from Robo3d for a burnt pin on the heated bed. The board is not exactly the same as my old one, so I am...
    Thread by: Ibc36070, Oct 9, 2016, 12 replies, in forum: Troubleshooting
  5. Ibc36070
    Post

    Solved Bed not heating. Please help

    Thanks for your time! I think I'll try the generic board and go from there.
    Post by: Ibc36070, Aug 28, 2016 in forum: Troubleshooting
  6. Ibc36070
    Post

    Solved Bed not heating. Please help

    I tried to search, but apparently what I was searching for was not the right thing. If you don't mind, how is Q3 the culprit if the pin is in D8...
    Post by: Ibc36070, Aug 28, 2016 in forum: Troubleshooting
  7. Ibc36070
    Thread

    Solved Bed not heating. Please help

    The bed on my r1+ has not been heating for some time, and the support team sent me a link to get it RMAed some time ago. That said, I got busy...
    Thread by: Ibc36070, Aug 28, 2016, 10 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again