1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Richard Shank
    Post

    Less than one month and Robo 3D R1+ stopped printing

    Thanks Rigmarol. Just so people don't think I freaked out and ran off. I'm gone for a week. I'll start trying to fix this when I get back next...
    Post by: Richard Shank, Sep 13, 2016 in forum: United States of America
  2. Richard Shank
    Post

    Less than one month and Robo 3D R1+ stopped printing

    It looks like I'm going to break mine on my first attempt too. I saw someone mention that you heat it up to "full temperature". How hot is that?...
    Post by: Richard Shank, Sep 13, 2016 in forum: United States of America
  3. Richard Shank
    Post

    Less than one month and Robo 3D R1+ stopped printing

    I just measured the screws. They are 5mm in diameter and 16mm long. The could be 8-32s. I'm an electrical engineer. I'm not very familiar with...
    Post by: Richard Shank, Sep 13, 2016 in forum: United States of America
  4. Richard Shank
    Post

    Less than one month and Robo 3D R1+ stopped printing

    Thanks Geof. The screws I'm referring to look like 10-32 flat head phillips and they hold the 'ten gallon hat" cover on to the base. They...
    Post by: Richard Shank, Sep 13, 2016 in forum: United States of America
  5. Richard Shank
    Post

    Unresolved Clogged extruder

    Can you tell me: 1) How to determine what nozzle I have in my brand new Robo 3d R1+? 2) Where to get and how to install an oiler. Please...
    Post by: Richard Shank, Sep 13, 2016 in forum: Troubleshooting
  6. Richard Shank
    Thread

    Less than one month and Robo 3D R1+ stopped printing

    I changed spools and the extruder won't print at all. Things were getting messy (cobwebs from the print head) before I changed spools but it was...
    Thread by: Richard Shank, Sep 13, 2016, 9 replies, in forum: United States of America
Showing results 1 to 6 of 6
Search Again