1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Joshedmondson87
    Post

    add support for builds

    Yes that is checked. Im trying to build a hulk figure but it wont build supports to his fingers so his hands can build. Is there a editor where i...
    Post by: Joshedmondson87, Dec 18, 2016 in forum: General Questions
  2. Joshedmondson87
    Thread

    add support for builds

    in currently using matercontrol right now. how do I go about adding support to my model before printing.
    Thread by: Joshedmondson87, Dec 18, 2016, 7 replies, in forum: General Questions
  3. Joshedmondson87
    Post

    Solved Unable to connect to printer

    2 days old. Its a short in the connector on the printer. I have a pencile wedged in the side right now to keep it still, i have a screen coming...
    Post by: Joshedmondson87, Dec 17, 2016 in forum: Troubleshooting
  4. Joshedmondson87
    Profile Post

    Frustrated

    Frustrated
    Status update by Joshedmondson87, Dec 16, 2016
  5. Joshedmondson87
    Thread

    Solved Unable to connect to printer

    First was loosing connection, now i can not connect to printer at all. Matter control says com3 in use as status. Windows pops up unable to...
    Thread by: Joshedmondson87, Dec 16, 2016, 3 replies, in forum: Troubleshooting
  6. Joshedmondson87
    Post

    Solved New r1+ printing way high

    Uninstalled mattercontrol then reinstalled, fixed this problem.
    Post by: Joshedmondson87, Dec 16, 2016 in forum: Troubleshooting
  7. Joshedmondson87
    Post

    Solved New r1+ printing way high

    Ill try that when i get home, i just did a restore on my other computer so im going to see if it works on that one. I also ordered the xxl lcd...
    Post by: Joshedmondson87, Dec 16, 2016 in forum: Troubleshooting
  8. Joshedmondson87
    Post

    Solved New r1+ printing way high

    I watched the video but it doesnt seem to be any of those issues, before the print it goes through the motion of checking the level and the nozzle...
    Post by: Joshedmondson87, Dec 16, 2016 in forum: Troubleshooting
  9. Joshedmondson87
    Thread

    Solved New r1+ printing way high

    Just got the r1+ yesterday and everything was going good until my computer decided to update in the middle of a print. Now when i start a new...
    Thread by: Joshedmondson87, Dec 16, 2016, 6 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again