1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. duke
    Post

    Unanswered Any advice on improving overhangs?

    Thanks, I've already gone through the 1st guide, but will definitely read the 2nd one.
    Post by: duke, Mar 13, 2017 in forum: Troubleshooting
  2. duke
    Thread

    Unanswered Any advice on improving overhangs?

    Hi guys, I'm printing what is essentially a sphere using PLA on Robo R1+ in Simplify3D. The bottom part of it, which is in contact with support...
    Thread by: duke, Mar 12, 2017, 4 replies, in forum: Troubleshooting
  3. duke
    Post

    Unanswered First layers too thick

    You guys are not gonna like this - I'm now using my uneven bed as an excuse for not adjusting the Z-offset when printing small parts. In the...
    Post by: duke, Mar 12, 2017 in forum: Troubleshooting
  4. duke
    Post

    Unanswered First layers too thick

    Thanks, I found it. I should use the lastest version (RCBF_MESH_PLUS_03-01) right? It looks like a lot more work than I have time for right now...
    Post by: duke, Mar 7, 2017 in forum: Troubleshooting
  5. duke
    Post

    Unanswered First layers too thick

    I'm only seeing 5 projects listed there and nothing about updating Marlin. Is it on this site? What's the difference between setting global...
    Post by: duke, Mar 7, 2017 in forum: Troubleshooting
  6. duke
    Post

    Unanswered First layers too thick

    Thanks for your reply. Here's my S3D startup script: G28 X0 Y0 Z0 G1 Z5 F5000 M565 Z-1.1 G29 I was mostly using the Global G-Code Offset (Z-Axis)...
    Post by: duke, Mar 7, 2017 in forum: Troubleshooting
  7. duke
    Thread

    Unanswered First layers too thick

    Hi everyone, I'm having a minor problem with my prints. The first few layers almost always come out too thick - you can see it in the attached...
    Thread by: duke, Mar 7, 2017, 9 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again