1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. user90983
    Post

    Solved Robo3D R1+ Z-axis endstop switch not engaging after carriage is lifted up. How to level?

    Guys, thanks so much! I was an idiot and didn't know that the smooth rods actually went into guides at the top of the case! They were forced out...
    Post by: user90983, Dec 19, 2020 in forum: Troubleshooting
  2. user90983
    Post

    Solved Robo3D R1+ Z-axis endstop switch not engaging after carriage is lifted up. How to level?

    The method I used for aligning the X gantry (the carrier on which the print-head slides on the x-axis, right?) is the following: Move the...
    Post by: user90983, Dec 19, 2020 in forum: Troubleshooting
  3. user90983
    Thread

    Solved Robo3D R1+ Z-axis endstop switch not engaging after carriage is lifted up. How to level?

    My Robo3D R1+ has always has this problem, but it's gotten so bad that I can't seem to fix it. The 3d-printing carriage that slides along the...
    Thread by: user90983, Dec 19, 2020, 6 replies, in forum: Troubleshooting
  4. user90983
    Post

    Unanswered PETG bed adhesion and/or oozing

    I tried the calibration circle that comes with MatterControl with those settings, and it seemed to work well, though I did notice some...
    Post by: user90983, Jan 14, 2017 in forum: Troubleshooting
  5. user90983
    Thread

    Unanswered PETG bed adhesion and/or oozing

    My Robo 3D Plus works well with PLA, but I was only able to get the color white with PETG, so I'm trying that. I followed some instructions I...
    Thread by: user90983, Jan 14, 2017, 4 replies, in forum: Troubleshooting
  6. user90983
    Post

    Unresolved New Robo 3D R1 Plus, z-axis end switch not registering

    Things have improved still further. I discovered the command to display the endstop status is M119. It was reporting the switch opened when the...
    Post by: user90983, Jan 12, 2017 in forum: Troubleshooting
  7. user90983
    Post

    Unresolved New Robo 3D R1 Plus, z-axis end switch not registering

    I think I improved the situation by taking the arch off and loosening then tightening the screw that holds the switch housing bracket to the...
    Post by: user90983, Jan 12, 2017 in forum: Troubleshooting
  8. user90983
    Thread

    Unresolved New Robo 3D R1 Plus, z-axis end switch not registering

    I just got a Robo 3D R1 Plus, and I'm dealing with an issue that seems to be described as one of the two z-axis end stop switches not being...
    Thread by: user90983, Jan 12, 2017, 2 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again