1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Ryan585
    Post

    White screen

    I have the exact same issue. It was fine when I turned it off but when I turned it back on the screen went white and wouldn't start up. I can't...
    Post by: Ryan585, Jul 11, 2017 in forum: Troubleshooting
  2. Ryan585
    Post

    C2 Filament Run-Out Detection

    Robo let me know how to disable the sensor. It's a temporary fix, but it can do until you can exchange or get a new sensor. "I have a quick fix...
    Post by: Ryan585, Apr 6, 2017 in forum: Troubleshooting
  3. Ryan585
    Post

    C2 Filament Run-Out Detection

    Is there a fix on my end for any of those issues?
    Post by: Ryan585, Apr 3, 2017 in forum: Troubleshooting
  4. Ryan585
    Post

    C2 Filament Run-Out Detection

    I can't seem to post the picture, but it seems that the red and black wires are connected.
    Post by: Ryan585, Apr 3, 2017 in forum: Troubleshooting
  5. Ryan585
    Post

    C2 Filament Run-Out Detection

    The filament is feeding the way you have it pictured. Just to verify; are you talking about the two connectors under where it says "robo" on the...
    Post by: Ryan585, Apr 3, 2017 in forum: Troubleshooting
  6. Ryan585
    Post

    C2 Filament Run-Out Detection

    I have the filament running through the hole in the black plastic thing in the back and up through a plastic tube. I'm not a professional with...
    Post by: Ryan585, Apr 3, 2017 in forum: Troubleshooting
  7. Ryan585
    Thread

    C2 Filament Run-Out Detection

    Hello, I just received my Robo C2 and started printing with it. The printer is printing fine, but it stops every 10-30 seconds stating "Filament...
    Thread by: Ryan585, Apr 3, 2017, 32 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again