1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Just Print
    Post

    Answered Auto levels then stops

    This is what the Gcode reads at the first error <-ok [78.788] ->N157 G1 X0 Y0 Z5 F5000*6 [78.789] <-Printer stopped due to errors. Fix the error...
    Post by: Just Print, Dec 10, 2018 in forum: Troubleshooting
  2. Just Print
    Thread

    Answered Auto levels then stops

    My ROBO 3D has been working great but today i went to print and all it will do is auto level then it stops once it dose the last level point....
    Thread by: Just Print, Dec 10, 2018, 3 replies, in forum: Troubleshooting
  3. Just Print
    Post

    Solved Y axis problems

    Thanks to all that responded to my question. I did figure out the problem. The Y axis stepper had a wire that was disconnected and not pushed...
    Post by: Just Print, May 4, 2017 in forum: Troubleshooting
  4. Just Print
    Post

    Solved Y axis problems

    Ok thanks you. I will check that out.
    Post by: Just Print, May 4, 2017 in forum: Troubleshooting
  5. Just Print
    Post

    Solved Y axis problems

    Ok hopefully they can direct me on How to tune it to work or get me some replacement parts heading my way. It dose have a warranty.
    Post by: Just Print, May 4, 2017 in forum: Troubleshooting
  6. Just Print
    Post

    Solved Y axis problems

    It is a new machine. Just shakes in place. When power is off I can move it front to back by hand. Belts are all good and nothing holding it...
    Post by: Just Print, May 4, 2017 in forum: Troubleshooting
  7. Just Print
    Thread

    Solved Y axis problems

    Just recived my ROBO R+1 and got it all set up and went to print first part and the Y axis will not move. All it dose is shake. Any ideas if it...
    Thread by: Just Print, May 3, 2017, 10 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again