1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. jwmueller
    Thread

    Hex Hotend Play

    I ended up having to replace my hex hotend after a heater fail. With my arm in a sling I did the job with well one hand, not fun but it lead to a...
    Thread by: jwmueller, Mar 3, 2018, 2 replies, in forum: Troubleshooting
  2. jwmueller
    Thread

    Updated Fan Duct from Robo

    File is too large - so here is a link to it. Thanks to Jason for emailing it over to us. Edit: It should now be up in the Robo Thingiverse...
    Thread by: jwmueller, Nov 6, 2017, 9 replies, in forum: Mods and Upgrades
  3. jwmueller
    Thread

    Z crashes during auto bed level

    Is anyone seeing Z crashes during the auto bed level process? I am finding that if I do not clean the IR sensor every three or so prints it will...
    Thread by: jwmueller, Aug 24, 2017, 9 replies, in forum: Troubleshooting
  4. jwmueller
    Thread

    R2 repair times

    Mine (R2) has been gone for near two weeks, aside from the tracking I have no clue if they got it. Called in today, they said a level 2 would...
    Thread by: jwmueller, Jun 29, 2017, 10 replies, in forum: General Questions
  5. jwmueller
    Thread

    Borosilicate Glass Bed Mod (sort of for now)

    Not being a huge fan (yet) of PEI print surfaces, I grabbed a Prusa Borosilicate bed that I had lying around collecting dust. Checked the size...
    Thread by: jwmueller, Jun 11, 2017, 23 replies, in forum: Mods and Upgrades
  6. jwmueller
    Thread

    X and Y Ringing on prints - possible solutions

    My first two prints have large areas of vertical space, and are showing really bad ringing. This is not belt ringing as it is perfectly regular,...
    Thread by: jwmueller, Jun 9, 2017, 127 replies, in forum: Troubleshooting
  7. jwmueller
    Thread

    Robo R2 Print Tests

    I am going to run just about every material I have in stock through the R2 and see how they all look. Up first though is a Cura spliced test on...
    Thread by: jwmueller, Jun 8, 2017, 5 replies, in forum: Show and Tell
Showing results 1 to 7 of 7
Search Again