1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Blakjak89
    Post

    Answered Z-axis starts printing 4 inches above the bed-R1+ Printer

    When I run G Code, my x is -0.00, y is 0.00, and z is 1.00. is this correct for leveling?
    Post by: Blakjak89, Jun 21, 2017 in forum: Troubleshooting
  2. Blakjak89
    Post

    Answered Z-axis starts printing 4 inches above the bed-R1+ Printer

    All that work and now it tries to print "backwards" meaning up in the air...it still levels in the air not on the bed
    Post by: Blakjak89, Jun 21, 2017 in forum: Troubleshooting
  3. Blakjak89
    Post

    Answered Z-axis starts printing 4 inches above the bed-R1+ Printer

    I found the switches, but only one is touching now. (the one on the right hand side). is there a simple fix to this?
    Post by: Blakjak89, Jun 21, 2017 in forum: Troubleshooting
  4. Blakjak89
    Post

    Answered Z-axis starts printing 4 inches above the bed-R1+ Printer

    does the head need to be all the way down or does that position matter?
    Post by: Blakjak89, Jun 21, 2017 in forum: Troubleshooting
  5. Blakjak89
    Post

    Answered Z-axis starts printing 4 inches above the bed-R1+ Printer

    Where exactly are those switches? Are you sure they are on the X-axis, if so do I need to flip it upside down to see them?
    Post by: Blakjak89, Jun 21, 2017 in forum: Troubleshooting
  6. Blakjak89
    Thread

    Answered Z-axis starts printing 4 inches above the bed-R1+ Printer

    So my Robo 3D R1+ tries to start printing almost 3-4 inches above the bed. Is this a calibration problem, or am i missing something in the gcode?...
    Thread by: Blakjak89, Jun 21, 2017, 12 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again